Plasmon V15 Manual do Utilizador descarregar pdf (Página 88)

Plasmon

15 AIT Tape Library User Manual

Page 86

Connecting to the Console Interfaced

This section describes how to connect your library to the host computer and access the console interface.

You can use console for upgrading firmware, creating a diagnostic listing, and viewing the LCD password.

Before accessing the console interface, you must have the following:

•

Host computer that uses an RS232 serial port.

•

A straight-through 9-pin serial cable (not a null modem cable) with a male “D” connector.

•

Terminal emulation software, such as HyperTerminal, that supports the ANSI 3.64 terminal

protocol.

NOTE

Plasmon recommends that you use HyperTerminal, a standard

communications package available with Windows.

Connecting the Serial Cable

Connect the 9-pin cable to the back of the library and to the host computer. The following figure shows the

location of the 9-pin serial port on the back of the library.

Figure 29. Serial Port Connector

9-pin serial port

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 137 138

Sem comentários

Plasmon V15 Manual do Utilizador Página 88